Brampton Technology - 5 Step Mixing Procedure

HOME

ABOUT BRAMPTON

SOLVENTS

ADHESIVES

ACCESSORIES

ENVIRONMENT

ENDORSEMENTS

DISTRIBUTORS

5 STEP MIXING PROCEDURE

1	Dispense equal amounts of part A & B by volume. For Pro-Fix 5&10, dispense only enough for one use.
2	Mix thoroughly until product has a uniform color.
3	Thoroughly coat the inside of the hosel with a round dowel or suitable applicator.
4	Spread a thin layer over the tip prepared (grit-sanded) shaft. Examine for complete coverage.
5	Insert shaft into hosel with a slight twist and align. Clean excess adhesive off with alcohol towelete. Leave undisturbed to cure.

ADDITIONAL INSTRUCTIONS FOR PRO-FIX 5&10

Quick setting adhesives have their own characteristics and must be used accordingly. Please follow these directions for best results.

Dispense only the amount you can use in two minutes.
Mix briefly but thoroughly.
Do NOT remix the material at any time during use.
Do NOT continue to use mixed product that has started to set or become gelled.
Do NOT move club while curing.

Following these instructions will give the maximum performance of 5&10 adhesive. Material that is over-mixed or used after cure is initiated will result in a reduction of properties and performance.